更新時間：2022-06-08
文章來源：http://gulfbaader.com/
閱讀量：22
由于家庭影院系統在音箱的安裝、擺位以及調試等方面都有一套嚴格的規范，這意味著用戶只有遵守這些規范來對音箱進行安裝和調試才能得到理想的聲音。下面為大家介紹家庭影院音箱的設置與總調試內容。
Because the home theater system has a set of strict specifications in the installation, positioning and debugging of speakers, it means that users can get ideal sound only by following these specifications to install and debug speakers. Now let's introduce the setting and general commissioning of the speakers in the home theater.
音箱的設置與擺放
Setting and placement of speakers
超低音音箱主要用來彌補主音箱低頻下限的不足。同時還可以增加低頻能量。因此，消費者在使用前必須設置好功放的低頻分頻點。設置分頻點時，應根據您選擇的音箱系統進行設置。
The subwoofer is mainly used to make up for the deficiency of the low frequency lower limit of the main speaker. At the same time, it can also increase the low-frequency energy. Therefore, consumers must set the low-frequency division point of the power amplifier before use. When setting the frequency division point, it should be set according to the speaker system you select.
與其他音箱系統一樣，您必須根據每個音箱系統的低頻響應設置每個通道的分頻點。分頻點設置好后，就可以定位音箱了。理論上，音箱可以放置在房間的任何地方。
Like other speaker systems, you must set the frequency division point of each channel according to the low-frequency response of each speaker system. After the frequency dividing point is set, the speaker can be positioned. In theory, speakers can be placed anywhere in the room.
但實際上，消費者需要嘗試將音箱放在房間內的不同位置進行聆聽，找出佳放置點。一般情況下，消費者可以將音箱放在前面。
But in fact, consumers need to try to put the speakers in different positions in the room to listen and find out the best place to put them. In general, consumers can put the speaker in the front.
音箱系統的總調試
General commissioning of speaker system
音箱系統系統的整體調試，測量每個音箱系統與人耳的距離（一般為高音喇叭與人耳的距離），將測得的距離值輸入功放。然后消費者在聽音位置使用聲壓計測量各聲道的輸出聲壓，并根據讀數獨立調節AV功放中各聲道的輸出電平，使各聲道的聲壓達到80dB參考聲壓值。然后音箱系統設置基本完成。
For the overall commissioning of the speaker system, first measure the distance between each speaker system and the human ear (generally the distance between the tweeter and the human ear), and input the measured distance value into the power amplifier. Then the consumer uses a sound pressure meter to measure the output sound pressure of each channel at the listening position, and independently adjusts the output level of each channel in the AV power amplifier according to the reading, so that the sound pressure of each channel reaches the 80dB reference sound pressure value. Then the speaker system setting is basically completed.
完成以上兩步后，其實對于大家粉的普通消費者來說，基本的調試就可以認為已經完成了。不過對于一些追求更好效果的消費者來說，建議使用均衡器來校正房間的頻響曲線。
After completing the above two steps, in fact, for ordinary consumers, the basic debugging can be considered to have been completed. However, for some consumers seeking better results, it is recommended to use an equalizer to correct the frequency response curve of the room.
為什么要這樣做？
家庭影院音箱廠家認為主要原因是大部分消費者的聽音環境的頻響曲線并不理想。當然，也有人認為加均衡器會影響音質，但如果房間的頻響曲線不理想，就會嚴重影響整體聲音平衡，從而導致整體音效變差。因此，在相對不理想的聆聽環境中，使用均衡器是一個不錯的選擇。
Why? Home theater speaker manufacturers believe that the main reason is that the frequency response curve of most consumers' listening environment is not ideal. Of course, some people think that adding an equalizer will affect the sound quality, but if the frequency response curve of the room is not ideal, it will seriously affect the overall sound balance, resulting in poor overall sound effect. Therefore, it is a good choice to use equalizer in a relatively poor listening environment.
還有一點要注意的是，消費者必須利用自己熟悉的軟件，并通過自己實際的聽感對音箱系統進行不斷的調整，這樣才能得到理想的效果。更多關于該產品的相關信息就來我們網站
gulfbaader.com咨詢了解吧！
Another thing to note is that consumers must use their familiar software and constantly adjust the speaker system through their actual listening sense, so as to get the ideal effect. For more information about this product, please visit our website at www.wenguangzhining Www. 68mn!
魯公網安備 37010202002516號
